Welding Processes

What is the difference between TIG and MIG welding?

TIG uses a non-consumable tungsten electrode and hand-fed filler; MIG feeds a consumable wire through a gun. Compare speed, skill, cost and best uses.

On this page
  1. The short answer
  2. How each process works
  3. Side-by-side comparison
  4. Which is easier to learn
  5. Which to choose by job
  6. Cost and equipment

The short answer

The main difference is the electrode and how filler metal gets into the weld. MIG (gas metal arc welding, GMAW) feeds a consumable wire through a gun, and that wire is both the electrode and the filler. TIG (gas tungsten arc welding, GTAW) uses a non-consumable tungsten electrode to make the arc, and the welder adds filler rod separately, usually with the other hand. Both use shielding gas to protect the weld pool from the air.

In practice: MIG is faster and generally easier to learn. TIG is slower and takes more coordination, but gives finer control and cleaner-looking welds, especially on thin metal and non-ferrous metals.

How each process works

MIG. You pull a trigger and the machine feeds wire at a set speed. The arc, wire feed and gas flow start together, so one hand holds the gun and the other is free to steady it. Voltage and wire feed speed are the main settings.

TIG. The arc is established with the tungsten, and the puddle forms from the heat of the arc. You add filler rod to the puddle as needed, and most machines have a foot pedal or torch control to adjust amperage as you weld. Argon is the usual shielding gas. Because the tungsten and rod have to stay clean, TIG is less forgiving of dirt and contamination.

Side-by-side comparison

MIG (GMAW) TIG (GTAW)
Electrode Consumable wire, also the filler Non-consumable tungsten
Filler Fed automatically Added by hand (not always needed)
Speed Faster Slower
Learning curve Gentler Steeper
Weld appearance Good, with some spatter Typically very neat and precise
Precision on thin metal Fair to good Excellent
Aluminum and stainless Workable, with the right setup A classic use for TIG
Tolerance of dirty metal Moderate Low; needs clean metal
Outdoors and wind Gas can blow away Gas can blow away
Equipment cost Generally lower Generally higher

Which is easier to learn

MIG is widely regarded as the easier of the two, since the machine handles filler feed and the single trigger keeps the coordination demands low. TIG requires you to manage the torch, filler rod and amperage control together, so most beginners take longer to get consistent results (see common TIG welding mistakes). Easier doesn’t mean that MIG is trivial: setting parameters correctly and avoiding poor fusion on thicker steel are skills too.

Which to choose by job

  • Auto body, general fabrication, repair of mild steel: MIG is a common choice because it’s fast.
  • Thin stainless, aluminum, exhaust, bike frames, visible welds: TIG is often preferred for control and appearance.
  • Production work with long runs: MIG, since it is easy to automate.
  • Outdoor, windy conditions: both gas-shielded processes struggle in wind. Stick or self-shielded flux-cored wire may be a better fit; see flux-cored vs MIG.
  • Dirty or rusty steel: neither is ideal; clean it first (see preparing metal for welding). TIG is the least tolerant.

Cost and equipment

MIG machines tend to cost less and are available as compact units that suit home shops. TIG setups generally cost more and add a torch, tungsten, filler rods and an argon supply; many TIG machines also offer AC output for aluminum. You will need the usual protective gear for either process, and the gas supply has a running cost.

For a wider look at the options, including stick and oxy-fuel, see welding processes and equipment.

The complete guide to welding processes

Welding Processes and Equipment: A Beginner's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →