The short answer
“Weld types” can mean different things, and people searching for this phrase usually want one of two lists:
- The five basic joint types: butt, lap, corner, tee and edge. This is the most common meaning in welding training.
- The five common welding processes: MIG, TIG, stick, flux-cored and oxy-fuel. These are covered at the end of this article.
The five basic weld joints
A joint describes how two pieces of metal meet. The weld is what fills or fuses it.
1. Butt joint. Two pieces lie in the same plane and meet edge to edge. It’s used for plate, pipe and sheet, and can be strong when fully penetrated. Thicker material is usually beveled (the edges are cut at an angle) so the weld reaches the full depth.
2. Lap joint. One piece overlaps another and the edge is welded, often with a fillet weld. It suits sheet metal and situations where precise edge alignment is hard, and it is the typical joint for resistance welding (see spot welding and seam welding).
3. Corner joint. Two pieces meet at an angle, usually about 90 degrees, forming the corner of a box or frame. The weld sits at the outside corner or is made as a groove or fillet depending on design.
4. Tee joint. One piece meets another at roughly 90 degrees, forming a “T.” It is commonly welded with a fillet weld on one or both sides, and is common in frames and structures.
5. Edge joint. The edges of two pieces, usually side by side, are welded together along the edge. It is typically used on thin sheet or where the load is low.
Weld types used on those joints
Joint and weld are different things. The weld type is the shape of the weld metal itself. Common ones include:
- Groove weld: made in a groove between the pieces, common on butt joints.
- Fillet weld: a roughly triangular weld in the corner of a tee, lap or corner joint.
- Plug and slot welds: weld metal fills a hole or slot to join overlapping pieces.
- Surfacing welds: deposit weld metal over a surface, such as in hardfacing.
- Spot and seam welds: produced by resistance processes.
Drawings use standard welding symbols to indicate which joint, weld type, size and process are required.
The five common welding processes
If you landed here looking for processes, the five usually named are:
- MIG (GMAW): continuous wire and shielding gas; fast and beginner-friendly.
- TIG (GTAW): tungsten electrode with hand-fed filler; precise on thin metal and non-ferrous alloys. See TIG vs MIG.
- Stick (SMAW): flux-coated rod; portable and suited to outdoor and thicker work.
- Flux-cored (FCAW): tubular wire with flux; high deposition and wind-tolerant in self-shielded form. See flux-cored vs MIG.
- Oxy-acetylene (gas) welding: flame from fuel gas and oxygen; used for light work, repair, brazing and cutting.
The full picture is in welding processes and equipment.
Choosing a joint
- Need maximum strength in the same plane? A butt joint with proper preparation is a common pick.
- Joining thin sheet or want easy alignment? A lap joint is often simpler.
- Building boxes or frames? Corner and tee joints are the usual options.
- Whatever the joint, clean fit-up matters; see how to prepare metal for welding.