What SAW is
Submerged arc welding (SAW) is an arc welding process in which an electric arc burns between a continuously fed wire electrode and the workpiece, buried beneath a layer of granular flux. “Submerged” refers to the flux, not water. The flux covers the arc and the molten pool, so there is no visible arc flash and little spatter, and it shields the weld from the air without a separate shielding gas.
SAW is usually mechanized or automated and is known for high deposition rates and deep penetration on thick material.
How it works
- Flux is laid down. A hopper feeds granular flux onto the joint ahead of, or around, the wire.
- The arc is struck under the flux. The wire touches the work (or is started with a special method) and the arc begins beneath the flux blanket.
- Flux melts into slag. Part of the flux melts, forming a molten layer that protects the weld pool, shapes the bead, and can add alloying elements or clean the weld metal.
- The head travels. Either a carriage moves the welding head along the joint, or the work moves beneath a fixed head.
- Unmelted flux is recovered. Loose flux can often be vacuumed up and reused, and the solidified slag is chipped or peels off the cooled weld.
Equipment
A typical SAW setup includes:
- A high-capacity power source, often capable of hundreds to well over a thousand amps, in constant-voltage or constant-current designs
- A wire feeder and welding head
- A flux hopper and delivery system, with recovery equipment in many shops
- A travel mechanism (tractor, boom or positioner)
- Controls to set travel speed, wire feed and voltage
Some setups use more than one wire or a strip electrode to raise deposition further or to clad large surfaces.
Flux and wire
Flux and wire are chosen as a pair, based on the base metal and the required weld properties. Fluxes differ in how they affect the weld, for example in how much alloy they add and how well they handle multiple passes. Wires may be solid or cored. Common base metals include carbon steels, low-alloy steels and stainless steels, and certain nickel alloys. Follow the manufacturer’s data for any combination you plan to use.
Advantages
- High deposition and travel speeds, which cut time on long welds
- Deep penetration, so thick joints may need fewer passes
- Good weld quality and consistent results when automated
- No visible arc and little spatter or fume escaping, which makes for cleaner working conditions than open-arc processes
- Flux can be recovered and reused
Limitations
- Position: Normally restricted to flat and horizontal fillet welding positions, because the loose flux would otherwise fall away.
- Thin material: Not suited to thin sheet, as the high heat input risks burn-through.
- Setup cost and effort: Equipment is larger and more expensive than manual processes, and it makes the most sense on repetitive or long welds.
- Flux handling: Flux has to be stored, delivered and cleaned up, and the slag must be removed.
- Hidden weld pool: The operator can’t see the arc directly, so joint tracking and setup matter.
Where it is used
- Pressure vessels, boilers and storage tanks
- Shipbuilding and barge construction
- Large structural steel fabrication, such as beams and girders
- Pipe manufacturing and wind tower sections
- Rail and heavy equipment fabrication
- Buildup and cladding of large parts, such as rolls (related to reclamation welding)
Safety and handling
Even with the arc hidden, SAW has hazards: high currents, hot slag and molten metal, and dust from flux handling. Moisture-contaminated flux can cause porosity and weld cracking, so manufacturers recommend storing it dry and following their instructions for drying and reuse. Follow the procedure, wear suitable protective equipment, and make sure the area has ventilation and fume extraction.
How SAW compares
For manual welding or out-of-position work, processes like stick, MIG and TIG are better suited. For heavier open-arc work with high deposition, see flux-cored vs MIG. SAW wins where plates are thick, the seams are long, and the work can be positioned flat.