The short answer
AC (alternating current) and DC (direct current) describe the type of electrical current the welder sends through the arc. With AC, the current reverses direction many times per second, typically 50 or 60 times per second to match mains frequency. With DC, the current flows in one direction, and you can choose which way: electrode positive or electrode negative. Each affects how the arc behaves, how deeply it penetrates and which electrodes run well.
What AC and DC mean
- AC: the polarity switches back and forth continuously. The arc goes through a brief zero point each cycle, so it can be less stable and some rods are designed specifically to cope with that.
- DC: steady polarity, which generally gives a smoother, more stable arc that is easier to start and control, particularly at low currents.
The machine type decides what you can use. A basic transformer welder provides AC only; transformer-rectifier and inverter machines provide DC, and some offer both. See how arc welding works for how these machines are built.
DC polarity: electrode positive vs negative
On DC, the way you connect the leads sets the polarity:
- DCEP (DC electrode positive), also called reverse polarity or DC+. Generally gives deeper penetration, and is the setting used for many common rods such as E6010 and E7018.
- DCEN (DC electrode negative), also called straight polarity or DC-. Generally gives shallower penetration and a faster burn-off of the electrode, and it is used with certain rods and thin material.
The terms “positive” and “negative” refer to the electrode lead, so check which of your machine’s terminals the electrode holder is plugged into and follow the rod manufacturer’s recommendation.
When AC is used
AC has a few practical advantages:
- AC-only machines are typically cheaper and rugged.
- AC tends to resist arc blow, in which magnetic forces push the arc off course on some joints and near the work clamp.
- Some rods are designed to run on AC with a low open-circuit voltage.
The trade-off is that it is a little harder to keep a smooth arc, and some rods will not run on AC at all.
Which rods work on which current
Always confirm against the packaging, but as a general guide:
- E6010: DC electrode positive only.
- E6011: AC or DC.
- E6013: AC or DC.
- E7018: AC or DC electrode positive (some formulations run better on one than the other).
More on each rod is in stick welding rods explained, and typical amperages are in the stick welding amperage chart.
Arc blow
Arc blow happens when magnetic fields from the welding current deflect the arc, which then wanders, spatters or leaves incomplete fusion. It is more common with DC, in corners and near the ends of plates. Remedies commonly include moving the work clamp, welding toward the clamp, shortening the arc, or switching to AC if the machine allows it. The effect of clamp position is discussed in where to put the ground when welding.
Choosing a machine
If you mostly weld steel with a range of rods and want smooth arcs, a DC-capable inverter is a common recommendation, partly because it is light and portable. If you need a simple, rugged and cheap machine for occasional repairs, AC-only may be enough, as long as you buy rods that suit it. Check the machine’s rated output and duty cycle against the rod sizes you plan to use. If you are setting up at home, see wiring a home welding shop for power supply basics.