Stick Welding

Where do you put the ground when welding?

Clamp the work lead (ground clamp) to clean bare metal on the workpiece, or to a metal table in good contact, close to the weld. Learn what to avoid and how to spot a bad ground.

On this page
  1. The short answer
  2. “Ground” versus work lead
  3. Where to clamp
  4. Clean contact
  5. Things to avoid
  6. Welding tables and fixtures
  7. Symptoms of a bad ground
  8. Safety

The short answer

Attach the ground clamp (properly called the work clamp) directly to the metal you are welding, on a clean, bare spot as close to the weld as is practical. If the workpiece sits on a metal welding table, you can clamp to the table, as long as the part and table make good electrical contact.

“Ground” versus work lead

In arc welding, the “ground” is not an earth connection in the usual sense. It is the return path of the welding circuit, the work lead, which carries the full welding current from the workpiece back to the machine. Without a good return, there is no complete circuit and no arc. The machine’s separate safety earth, via its power cable, is a different thing. The circuit is explained in how arc welding works.

Where to clamp

  • On the work itself wherever possible, which gives the shortest and most direct current path.
  • Near the weld zone, commonly within a few feet, so the current does not travel through unintended parts of the structure.
  • Where the clamp will not get in your way or be covered by weld spatter.

If you are welding a long assembly and the arc seems to wander, moving the clamp to the other side of the joint can help, which is one of the standard remedies for arc blow (see what is AC and DC arc welding).

Clean contact

Rust, paint, oil, mill scale and powder coating all resist current. Grind or wire-brush a small patch to bright metal, then clamp firmly. A weak or dirty connection can cause a weak, stuttering arc, a hot clamp or cable, and sometimes rods that keep sticking; see why your stick electrode keeps sticking. Check the clamp’s spring and jaws and the cable connections periodically.

Things to avoid

  • Bearings, hinges and swivel joints. Do not let welding current pass through moving parts. The current can arc across the contact surfaces and pit or damage them. Place the clamp so the current’s path stays on the solid part being welded.
  • Vehicles and electronics. Modern vehicles contain sensitive electronics. The general guidance is to follow the manufacturer’s instructions, disconnect the battery, and clamp close to the repair. If you are unsure, consult a professional. More vehicle-specific precautions are in welding vehicle repairs.
  • Pipes carrying gas, fuel or electricity, or equipment that is wired up. Do not weld on these without proper isolation and permission.
  • Painted or galvanised surfaces where you would be tempted to clamp on top of the coating, instead of cleaning it.

Welding tables and fixtures

A steel welding table is a convenient place to clamp, but joints between the table and the work add resistance. Metal-to-metal contact should be firm, and the table should not be painted at the clamp location. Some welders attach a second clamp or a dedicated clamp bracket to the table to keep the connection consistent.

Symptoms of a bad ground

  • The arc is hard to start or cuts out.
  • Amperage seems to be lower than set.
  • The clamp or cable gets unusually hot.
  • Spatter is excessive and beads are erratic.

If you notice these, reclean the contact point and check the cable and clamp before adjusting anything else.

Safety

Switch off the machine and unplug it before replacing cable ends or clamps. Replace damaged cables rather than taping over them, and keep leads away from sharp edges and wet areas. For an overview of how to start practising, see arc welding lessons.

The complete guide to stick welding

How Arc Welding Works: Stick, MMA and the Welding Arc
Read the guide

Keep exploring

Guides from other topics

All topics →