The short answer
With stick (SMAW/MMA) welding, the usual advice is to pull, also called dragging or backhand: the rod points back toward the finished weld and you move away from it. With processes that produce slag, including stick and flux-cored welding, this keeps the slag behind the puddle. With MIG, either direction is used, and the choice depends on the bead shape and penetration you want.
Why you drag with stick welding
Stick electrodes leave a layer of molten slag over the weld. If you push, with the rod angled ahead of the puddle, that slag can run in front of the arc and get trapped in the weld, which is called slag inclusion. Dragging keeps the slag trailing behind the puddle, where it can solidify on top and be chipped away. It also lets you see the leading edge of the puddle and the joint ahead of it, so it is easier to steer.
Typical travel angles
The travel angle is the lean of the rod along the direction of the weld. For a drag technique, a modest lean is common. Many sources suggest roughly 5 to 30 degrees from vertical, with about 10 to 15 degrees being a typical starting point, depending on the electrode and joint. Follow the rod maker’s guidance where available; some rods like a steeper angle, others a nearly upright one.
The work angle is the other half of the setup, meaning the angle from side to side relative to the joint. For a T-joint fillet this is typically around 45 degrees to each plate.
Exceptions and position notes
- Vertical up: the welder usually leans the rod slightly upward, which you can think of as a slight push uphill, and uses a weave or a stepping motion (see vertical up welding technique). The difference is mostly in the way the puddle is controlled against gravity.
- Vertical down with certain rods is used on thin material, and the angle is different again.
- Overhead: keep a short arc and a small puddle, as covered in overhead welding technique and settings. See stick welding rods explained for rod choice in overhead work.
- Easy-slag rods: some welders push lightly with rods like E6013 in the flat position because their slag is quite manageable. It is not the standard recommendation, and it carries more risk of slag trapping, so learn to drag first.
Push vs pull with MIG and flux-cored
- MIG (GMAW): both are used. Pushing (forehand) typically gives a wider, flatter bead and good visibility of the joint, and is popular on thinner material. Pulling (backhand) tends to give a narrower, more convex bead and is often associated with deeper penetration. Online opinion on penetration differences varies, so test on scrap in your own setup.
- Flux-cored (FCAW): with slag-forming wires, pulling is generally recommended for the same reason as in stick welding. For how the two wire processes differ, see flux-cored vs MIG welding.
Work angle and the rest of technique
Direction is only one part of a good weld. Arc length, speed and rod feed matter equally, and are practised in arc welding lessons and how to lay a weld bead. If your rod keeps freezing in place, look at why your stick electrode keeps sticking.