What sticking means
When you strike an arc, the rod tip touches the work for an instant. If the arc does not establish immediately, the tip can fuse to the plate and the rod freezes in place, or the rod sticks mid-weld when the arc length collapses. It is one of the most common beginner frustrations, and it is rarely caused by a faulty machine.
How to free a stuck rod
- Twist or snap the rod sideways to break the small weld, or
- Release the rod from the holder if it will not come free. Do not keep the holder squeezed on a stuck rod, because the circuit is still live and the rod will get very hot.
Never grab the stuck rod with a bare hand, as it can be hot. Keep your helmet down while you free it in case the arc restarts, and let it cool before handling.
Common causes
Amperage too low
The most common cause. If the current is too low for the rod diameter, the rod does not melt off quickly enough, so the tip tends to freeze into the pool. Look at the rod packaging for the recommended range and increase a little at a time. Typical starting values are in the stick welding amperage chart.
Starting technique
If you hold the rod against the plate too long, or lift too slowly, it freezes. Scratch or tap, and lift immediately. Practise starts on scrap until they feel automatic; the techniques are described in arc welding lessons.
Arc too short
Pushing the rod too close to the work while welding shorts out the arc and makes the rod stick. As the rod burns shorter, you need to keep feeding it forward at the rate it burns. A useful reference is to hold an arc about the diameter of the rod’s core.
Damp or damaged rods
Rods that have absorbed moisture, or whose coating is cracked or chipped, behave erratically: spluttering arcs, heavy spatter, and sticking. Low-hydrogen rods like 7018 are especially sensitive; see storing and drying 7018 rods. Replace rods with damaged flux.
Poor ground
A dirty or loose work clamp reduces the current actually reaching the arc, which acts like low amperage. Clean the contact spot and re-clamp. See where to put the ground when welding.
Wrong polarity or machine too small
Using a rod on the wrong polarity can make it hard to start and stay lit (for instance, E6010 needs DC with the rod positive). Check the rod’s requirements and your machine’s settings; see what is AC and DC arc welding. Also, a small machine or a long, thin extension cord may not deliver enough output for a large rod. Try a smaller diameter.
Dirty metal
Heavy rust, paint, mill scale or oil make starts unreliable. Clean to bright metal at the start point. See how to prepare metal for welding.
A quick troubleshooting order
- Check that the work clamp is on clean, bare metal.
- Check the rod is dry, undamaged and matches your polarity.
- Raise the amperage by a small step.
- Practise a faster lift on scrap.
- Watch your arc length and keep feeding the rod forward as it burns.
If the problem persists, try a different rod of the same type; a bad batch is uncommon but possible. For rod choices, see stick welding rods explained.