Jig vs fixture
The two words are often used interchangeably in welding shops, but they have slightly different meanings:
- A fixture holds and supports the parts in the right position while you tack and weld them.
- A jig also holds the work but additionally guides the tool or sets a fixed layout, so each part comes out the same.
In everyday welding the distinction matters less than the goal: hold the pieces accurately in the same place every time.
Why use them
- Accuracy. Parts are located by stops and clamps rather than by eye.
- Repeatability. The second and tenth piece match the first.
- Less distortion. Heat makes metal move. Holding the parts can reduce, though not eliminate, that movement.
- Speed. Setup time falls because you are not measuring and re-measuring each piece.
- A third hand. Both hands are free for the torch and filler.
Common types
- Magnetic angle holders. Small magnets with fixed angles, often 45, 90 and 135 degrees, used for quick fit-up. They suit light work. Heat can weaken magnetism, and arc blow can occur near strong magnets, so use them thoughtfully.
- Clamps. C-clamps, locking pliers, toggle clamps and corner clamps hold pieces against a stop or each other.
- Squares, V-blocks and stops. Help locate tube, bar and plate, and set angles.
- Fixture tables. Flat steel tables with a grid of holes accept pins, stops and clamps in many positions. They can be bought or built. See what is the ideal size for a welding table.
- Custom jigs. Steel plate and bar tack-welded to fit one part, often for frames, brackets or repeat products.
Designing a simple one
- Start from the finished part. Know the key dimensions and which ones matter most.
- Locate, then clamp. Use stops to set position and clamps to hold it. Avoid depending on clamps alone for location.
- Do not over-constrain. Locking a part so rigidly that it cannot contract may cause stresses or cracking in some joints. Think about how the weld will shrink.
- Leave access. Make sure you can reach every weld with the torch or electrode at the correct angle.
- Plan for removal. The finished piece must be able to come out of the fixture.
- Protect the fixture. Raise parts slightly or use shims where spatter could weld the work to the fixture, and keep fixture surfaces clean.
Materials
Steel is the usual choice because it is strong, heat tolerant and easy to cut and weld. Fixture tables are commonly built from steel plate. Some shops use 3D-printed tooling for light-duty positioning away from the arc, but high heat and spatter can damage plastic, so confirm suitability first. Do not use galvanized or coated steel for a jig without considering fumes. See welding shop ventilation and fume extraction basics.
Mistakes to avoid
- Tack welding the part to the fixture by accident
- Clamping so tightly that parts bow when released
- Placing the ground clamp so that current passes through delicate parts of the jig
- Forgetting heat expansion when setting final dimensions
- Building the jig first and checking access later
If you are still planning your shop, see setting up a welding shop for where jigs and tables fit among the other equipment.