Gas and Forge Welding

Why use borax when forge welding?

Borax is the classic forge welding flux: it shields hot steel from air and dissolves oxide so the surfaces can bond. Learn how to use it and protect your forge.

On this page
  1. Short answer
  2. What scale does and what flux fixes
  3. Hydrous versus anhydrous
  4. How to apply
  5. Effect on forge linings
  6. Alternatives
  7. Safety

Short answer

Borax is used as a flux. At welding heat it melts into a glassy liquid that coats the steel, keeps air away from the surface, and dissolves the iron oxide (scale) that would otherwise stop the pieces from bonding. With a clean surface the two pieces can come into direct contact and join when hammered.

What scale does and what flux fixes

Steel at forging temperatures reacts quickly with oxygen and forms black scale. Scale on the faces of a joint acts as a barrier. A weld needs clean, bare metal pressed against clean, bare metal.

Borax helps in a few ways:

  • It forms a liquid layer that limits contact between the steel and the air.
  • It dissolves iron oxides that are already present, helping to carry them out of the joint when the pieces are hammered together.
  • It lowers the temperature at which those oxides turn liquid, so they can be squeezed out as the pieces come together.

Flux does not replace good preparation or the right heat. Dirty or poorly shaped surfaces can still trap scale. See what temperature steel can be forge welded at.

Hydrous versus anhydrous

Household borax (the sort sold for laundry) is hydrous, meaning crystals that contain water. When heated, the water boils off and the powder swells, bubbles and can pop off the work before it melts into a coating. Many smiths therefore either heat borax in a container first to drive off the water, or buy anhydrous borax, which has already been dried and melts more smoothly.

Both work, but anhydrous borax is generally easier to use. Plenty of smiths also mix borax with other additives, such as iron filings or boric acid, in commercial or homemade flux blends.

How to apply

  1. Heat the steel to a moderate orange-red, hot enough for the borax to stick and melt but below welding heat.
  2. Sprinkle or dip the work in the borax so the joint faces are covered.
  3. Return it to the forge and bring it to welding heat. The flux should be liquid and shiny.
  4. Weld promptly and avoid leaving the flux on a long time at high heat, since it can burn off.

Effect on forge linings

Molten borax is aggressive toward many refractory materials. It can eat into firebrick, kiln wash and some insulating linings, especially in gas forges where the flux drips onto the floor. Smiths commonly protect the forge with a sacrificial floor, such as a kiln shelf, a plate or a replaceable brick, and keep the pieces they are fluxing away from burner ports. See our forge welding in a propane forge page for more on forge care.

Alternatives

Some smiths use commercial welding fluxes, which often contain borax along with other ingredients, and a few weld without flux. Welding without flux is possible in some cases, particularly with a very clean, reducing atmosphere and good technique, but it is less forgiving, and flux is the usual choice for beginners.

Safety

Borax is commonly sold as a household product, but it is not harmless. Avoid breathing the dust, keep it away from food and children, and read the product’s safety information. Fluxed steel at welding heat can spit and throw hot droplets, so wear eye protection and keep others back. If you are not yet comfortable with the basics of heating metal with fuel gas, our gas welding overview is a reasonable starting point.

The complete guide to gas and forge welding

Gas Welding: How Oxy-Acetylene Welding Works
Read the guide

Keep exploring

Guides from other topics

All topics →